hi,

I am following this thread...

You will find a sopc project using the controller here : https://roulette.das-labor.org/bzrtrac/wiki/soc-lm32

--

2008/3/5, Magnus Wedmark <magnus.wedmark@...>:

--- In minimigtg68@yahoogroups.com, Jörg Bornschein <jb@...> wrote:
>
> Magnus Wedmark wrote:
>
> Hi everyone...
>
> > Anyone tried? Anyone working at it right now? I own a Digilent
> > Microblaze Starterkit and would really like to be able to boot an
> > Amiga on it. It comes with a Spartan-3 1600E so I think it would be
> > able to sport the complete solution with bvoth Minimig and TG68.
> >
> > [..]
> >
> > One of the problems I have is thta I'm new to handling the onboard
> > 64Mbyte DDR2 memory so that si probably one obstacle to try and
get over..
>
> Digilent seems to have removed this board from its page -- so I can't
> verify: But isn't this board the big brother of the Spartan-3 500E
> StarterKit? I think it does use a DDR(1) memory.
>
> I'd expect the verilog memory controller at
>
> https://roulette.das-labor.org/bzrtrac/wiki/wb_ddr
>
> to work fine on that borad...
>
>
> j.
>

You are correct! It is DDR-memory and the 1600 is a "bigger brother"
of the more common 3E-Starter Kit with its 500K-device.

Thank you for the tip about the DDR-controller. I've seen it but I
would really like a good example of it in use.. Have you seen some?
I'm used to working with SRAM so if it only could be just as simple..

Best Regards
Magnus

--
--
Visit my personal page: http://ronivon.costa.googlepages.com/
--
Ronivon C. Costa
IBM TIVOLI Certified Consultant & Instructor
VOIP Phone: (+55) (19) 3119-7083 (Brasil) - Cel: (+351) 96 676 4458 (Portugal)
Skype: ronivon.costa  / Messenger: ronivon@...