Hi!

I did mean thinner. Admittedly we were using a 6 layer board as I
recall (4 signal, 2 power/gnd) -- so it had to be thinner than what
we use for our other boards..

Kurt

On Thu, May 12, 2005 at 12:47:01PM -0000, Vital wrote:
> Kurt,
>
> You meant "thinner" or "thicker"? I did a test using a generic board
> (1.8mm thick) and I had to put two business cards behind it to have
> it correctly pressing the GBA contacts. The total thickness (board +
> cards) was 2.2mm.
>
> Vital
>
> --- In gbadev@yahoogroups.com, Kurt Mahan <kmahan@x> wrote:
> > When you go to fab your board remember the board "thickness" is
> important.
> > As I recall the GBA Cart board (at least for the connector) is
> thinner
> > than what you would normally get.
> >
> > Kurt
> >
> > On Wed, May 11, 2005 at 02:15:15PM -0000, Vital wrote:
> > > Hello,
> > >
> > > Could anybody send me a template for the GBA cartridge PCB?
> > > A Protel 99 pcb template would be great, but even a mechanical
> drawing
> > > will help a lot.
> > >
> > > thanks,
> > > Vital

--
/**
* Kurt Mahan kmahan@...
*/